The gateway to online resources and design support for engineers, powered by RS ComponentsAllied

Forum

+Post a new topic

DESIGNSPARK Ver4

Avatar Posted by Rachael at

    I have down loaded Ver.4 but I have NOT been asked for an activation code.
    I found the serial number and entered it into the serial No. Request and have been told an activation number has been sent
    ? What do I do with it when I receive the code by Email.
    I tryed to use the program but am told that a file is missing.
    I then delete the message and DESIGNSPARK is loaded but I don't know which version is loaded.
    I think I'm getting visions or may be I'm really in a Coma HELP""" Please help me "OR WAKE ME UP"

    Rachael

    Replies

    • Avatar

      Posted by MikeBK at

      Hi, if you install V4 on top of V3 your V3 activation is inherited and you might not be asked to re-enter the activation code. If you can save your work then the program is activated. To find out your software version click help>about this gives the version and the activation status.

      If any issues with activation I suggest emailing support from Help>support in DesignSpark PCB. Please also check http://designspark.com/discuss/viewtopic.php?f=11&t=9514&sid=322cbe2c6a441d64883a23e9f15dea81

    • Avatar

      Posted by Rachael at

      MikeBK wrote:Hi, if you install V4 on top of V3 your V3 activation is inherited and you might not be asked to re-enter the activation code. If you can save your work then the program is activated. To find out your software version click help>about this gives the version and the activation status.

      If any issues with activation I suggest emailing support from Help>support in DesignSpark PCB. Please also check http://designspark.com/discuss/viewtopic.php?f=11&t=9514&sid=322cbe2c6a441d64883a23e9f15dea81


      Thank's MikeBK
      Your advice was good and I am now using the Ver4.

      ALL THE BEST
      Rachael

    Post a reply