How to make power rails with Designspark
Posted by Boss at
I haven't tried this but why not try a SIL header 0.1in pitch in schematic and connect every pin? You can add as many pins as required by cascading SIL's in series, or create your own in the library.
In the PCB layout just track between pins and chose a " power norm" track thickness. This should be close to what you show.
Replies
-
Hello
I would like to create power rails like on the PCB board from adafruit below.
I tried using tracks but that gives me an track to drill hole error en I tried with adding copper which gives me a pad to shape error when I check the desing rules.
How do I create these power rails?
Best regards
Jantje