The gateway to online resources and design support for engineers, powered by RS ComponentsAllied

Forum

+Post a new topic

Adruino Shield layout for DesignSpark?

Avatar Posted by dalich at

Are there any layout files avialble for DesignSpark for the basic Arduino Shield?  I downloaded some version .lrb file from the Arduino site, but I can't seem to figure out how to convert them.

Thanks in advance for any help!

Dan

Replies

  • Avatar

    Posted by MikeBK at

    Hi Dan,

    You can convert any Eagle files to DSPCB by following Help>tutorials>eagle conversion

    If you are using Eagle 6.x please email the support mailbox for updated ULP files

    Hope that helps

    Mike

  • Avatar

    Posted by dalich at

    It does not look like these are EAGLE files.  (.sch  .ulp  .eis  .eip)?

    Does anyone know where the EAGLE files for the Arduino footprint may be?  I know Ardino is open source, but I'm havinf a tough time trying to get all this stuff figured out.

    Anyone willing to help desgin a board for me?

    Dan

  • Avatar

    Posted by nertohmot at

    'llo Dan,

    The eagle files can be found at http://arduino.cc/en/Main/ArduinoBoardUno under the section "Schematic & Reference Design", located about one quarter down the page.

    ... what board design did you have in mind ?

    Cheers,

    Tom

     

Post a reply